Shiny Thin Crystal - Silicone Mold for Resin, Crystal Earring mold, Crystal Crafts MLD2
Welcome to Deko Mold! Molds for resin, wax, polymer clay, candy/chocolate, concrete, low melt metals and MORE! We hand design and sculpt each piece before casting, no recasts like other molders!
Silicone Material Options:
★ OPAQUE (coloured): Economical and great quality! This silicone is very flexible and long lasting. Use at temperatures -65°F to 400°F (-19°C to 205° C).
★ WATER CLEAR (Transparent): Premium material and best quality, it contains more platinum silicone so its a bit mroe costly! This silicone is compatible with most UV resin and UV cure systems as the UV light can penetrate the silicone to cure the entire piece. This silicone is also food safe for tasty treats, which when used with most foods should last almost indefinitely. This silicone is very flexible and long lasting, consistent use at high temperatures and with resin will begin to cloud the silicone but cast pieces will remain smooth. Use at temperatures -65°F to 400°F (-19°C to 205° C).
Item Details:
★ CAST PIECE SIZE: 40mm x 10mm x 10mm
★MOLD DIMENSIONS: 50mm x 35mm x 15mm
★ We use the HIGHEST quality vacuum degassed silicone (NO BUBBLES)
★ Our Molds create GLOSSY SHINY resin casts (unless otherwise specified in the listing)
★ Our Molds are FLEXIBLE for easy release (no release agent needed)
★ Our Molds LAST for many casts (NO resin sticking and mold breaking/tearing like “bargain” molds made of hard rubber)
******Find all the resin casting guides you need to make beautiful pieces of art on our website blogs! *******....it's easier than you think!!!
SILICONE MOLD CARE INSTRUCTIONS
• DON’T TOUCH the inside shiny part of the mold. This will cause permanent scuffs that will show in your final cast.
• Use scotch tape to gently clean the mold. Tap the spot lightly where there are loose particles.
• USE EXTREME CAUTION when using a torch/heat gun to pop bubbles in the resin. It may rip the mold upon demolding your fully cured resin. Instead try a mist of alcohol over the resin.
• Make sure the resin is fully. Uncured resin may rip the mold.
• Please follow all safety precautions when using resin. It is very toxic.
• Plastic Wrap/Bag Marks on trays will go away within 48-72 hours.
• If you have further questions or concerns about your mold, please shoot me a message on Etsy and I’ll get you taken care of.